White or Neutral Waxed (sandable) Brushing Gelcoat for Repairs and Finish Coats

FOR REPAIR AND RESURFACING OF FIBERGLASS BOATS, ATV’s, RV’s TUBS

Clean and degrease/dewax surface with Acetone. Apply only over fibreglass or Gelcoat. Clean brushes and tools with acetone. Sand and dewax with Acetone between coats.

Add 1.5 % MEKP Hardener (8 drops per oz.) above 20C/70F, 2 % (10 drops per oz.) below.

Mix only volume of Gelcoat you can use within 10 to 15 minutes. Working time 15 to 20 min.

Sandable in 3 to 4 Hrs, longer below 15C, do not use below 8C.

Brush or Roll out as smoothly as possible over clean sanded to 220 grit Gelcoat or Polyester Resin. Gelcoat does not flow like paint so will need to be wet sanded to 1200 grit and buffed to blend and achieve a high gloss.

250ml/8oz includes hardener

1l/1qt/  includes hardener

4l/1G

White or Neutral Unwaxed Brushing or Spraying Gelcoat for Moulds

USE IN MOULDS FOR FIBERGLASS PARTS or for REPAIR, RESURFACING OF BOATS,

Use unwaxed Gelcoat when applying multiple layers or covering with fiberglassing a mould.

Gelcoat or resin can be applied over existing cured unwaxed Gelcoat without sanding. Wet sand cured unwaxed Gelcoat or add 3% Air Dry to the last coat only for easier final sanding

Add 1.5 % MEKP Hardener (8 drops per oz.) above 20C/70F, 2 % (10 drops per oz.) below.

Mix only volume of Gelcoat you can use within 10 to 15 minutes. Working time 15 to 20 min.

Recoat when previous coat starts to gel, 30 to 60 minutes. Apply fiberglass without sanding after hard cure, minimum 4 hr or overnight.

Brush or Roll out as smoothly as possible over clean sanded to 220 grit Gelcoat or Polyester Resin.

4L/1G

20L/5G